North American Network Operators Group

Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

Re: [NANOG] Routing table for BGP

  • From: Tuc at T-B-O-H
  • Date: Fri May 16 10:59:28 2008

> 
> Hi,
> 
> 
> I would like to know what route should i accept from internet full or
> partial?
> if Partial then what routes should i accept? and how many route does my
> router have if i will go for Partial routing table?
> 
> actually I am trying to understand it by concept... my organization is small
> but I want to know if it is large organization or small provider then what
> kind of routes do i need in my routing table?
> 
Hi,

	If its only 1 provider, then probably taking just "default route"
is necessary. If you have 2, then it depends on your setup.

	I prefer to always take full routes from upstreams, as long as there
are good communities within that feed. This way I can vary what I accept
or don't accept without the need to constantly contact the upstream. If
not, then I have to fiddle more on my end, but I always keep the control.

	I personally run 2 routers (Ok, switches with routing code, so
my memory footprint is severely limited) each with a link to a provider.
I ask for full routes PLUS default route. Internally, I discard /24's on
both links, and pref up the communities like customer and send them over
to the other router with the default route. Saves me alot of memory, plus
gives me alot of control.

			Tuc/TBOH

_______________________________________________
NANOG mailing list
[email protected]
http://mailman.nanog.org/mailman/listinfo/nanog