North American Network Operators Group
Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

Re: Why can't I default Originate?

  • From: Haesu
  • Date: Tue Jul 08 17:05:31 2003 
After you applied default-originate to peer-group, have you done soft-clear of your bgp session?

It usually takes a little while for changes in config to propagate, unless you force an update using soft clear...

-hc

-- 
Sincerely,
  Haesu C.
  TowardEX Technologies, Inc.
  WWW: http://www.towardex.com
  E-mail: [email protected]
  Cell: (978) 394-2867

On Tue, Jul 08, 2003 at 12:43:35PM -0700, Vandy Hamidi wrote:
> 
> Platform:
> 	Cisco 7206VXR
> SW:
> 	Version 12.2(15)T2
> 
> router#sh run | b bgp
> 	router bgp 65011
> 	 no synchronization
> 	 bgp log-neighbor-changes
> 	 bgp confederation identifier 12345
> 	 bgp confederation peers 65001 65021 
> 	 bgp deterministic-med
> 	 bgp dampening
> 	 network 1.2.3.0 mask 255.255.255.0
> 	 neighbor Confed-Peer-Group peer-group
> 	 neighbor Confed-Peer-Group update-source FastEthernet1/1
> 	 neighbor Confed-Peer-Group next-hop-self
> 	 neighbor Confed-Peer-Group version 4
> 	 neighbor Confed-Peer-Group soft-reconfiguration inbound
> 	 neighbor Confed-Peer-Group filter-list 2 in
> 	 neighbor Confed-Peer-Group filter-list 1 out
> 	 neighbor 10.1.2.75 remote-as 65001
> 	 neighbor 10.1.2.75 peer-group Confed-Peer-Group
> 	 neighbor 10.1.2.75 password 7 05211F2C105211F2C1666B
> 	 neighbor 10.1.2.76 remote-as 65001
> 	 neighbor 10.1.2.76 peer-group Confed-Peer-Group
> 	 neighbor 10.1.2.76 password 7 05211F2C105211F2C1666B
> 	 no auto-summary
> 
> 
> router#conf t
> Enter configuration commands, one per line.  End with CNTL/Z.
> 
> router(config)#router bgp 65011
> 
> router(config-router)#neighbor 10.1.2.75 default-originate 
> % Invalid command for a peer-group member
> router(config-router)#
> 
> According to Cisco:
> All members of a peer group must share identical outbound announcement policies (such as distribute-list, filter-list, and route-map), except for default-originate, which is handled on a per-peer basis even for peer group members. 
> 
> I've also tried to apply to the peer group.  The command is accepted, but no default origination of 0/0 is advertised to the peer(s).
> Thanks in advanced for any help,
> 
> 	-=Vandy=-