North American Network Operators Group Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical Re: Need help with Cisco VLAN bridging....
Craig, Apart from other suggestions, I think you also can do this: 1)Put ip address at both ends of the DS3; 2) Esbalish tunnels for each of your vlan using different loopback interfaces; 3)put the vlans in their respective tunnles using brigde-group; 4) use rate limit based on the soure of loopback interface of the tunnel to control how much each tunnel(vlan) can use the DS3; Not sure wether you want to turn on the IRB, probably not. Of course this is preety urgly using layer 3 to solve layer2 problem, but just off the top of my head. HTH Kent Yu ----- Original Message ----- From: "Craig Holland" <[email protected]> To: "[email protected] Edu" <[email protected]> Sent: Friday, February 09, 2001 5:22 PM Subject: Need help with Cisco VLAN bridging.... > > Has anyone had experience bridging multiple VLANs accross a clear-channel > DS3? I have 2 3640's populated with 1 FE and 1 HSSI. They are connected by > a DS3. I've tried a couple of different configs, including turning one > router into a frame swich and building a PVC for each VLAN, but the bridging > didn't seem to work. I've tried running SDE directly between the HSSI > ports...and that didn't seem to work. I'm up a against a deadline here, and > would greatly appreciate any help you can offer. I've also tried a couple > of IRB configs. > > Thanks in advance, > craig > > > > Craig Holland > Network Engineer > Yahoo! Inc. > (408)731-3572 > Y!Messenger: cholland > >
|