North American Network Operators Group
Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

Re: Question ??

  • From: Michael Park
  • Date: Tue Aug 12 09:53:40 1997 
this is nanog.
not the mrtg mailing list.

goto http://ee-staff.ethz.ch/~oetiker/webtools/mrtg
* Mailing list archives are at http://www.ee.ethz.ch/~slist/mrtg

    ______ 
    \____/     Michael Park        EMail: [email protected]
     \__/      Network Engineer    Phone: 201 928 2954
      \/       IDT Corporation     Pager: 800 225 0256 PIN: 85452     


On Mon, 11 Aug 1997, Ignacio Funes Maderey wrote:

> 
> 
> I have tried to run mrtg with my router (Cisco 7500). This router has a 
> controller which accept an E1 and divides it as you want. The interfaces
> that are not directly connected to this controller are OK (for example
> interfaces such as Serial5/2, Ethernet3/5, etc...), but I have problems
> with those interfaces such as (Serial5/0:14, Serial5/0:13, etc.). The
> problems arise since I run cfgmaker [email protected]_ip, because the ports
> related with the interfaces directly connected to the controller are
> wrong.  In fact, when I run ./mrtg mrtg.cfg I get the next error messages:
> 
> CFG Error in "maxbytes[enepacatlan(rdi/e1)]": 256000  must be a Number
> smaller than maxint
> 
> ........
> 
> What should I do??????
> 
> I will appreciate your help.  Thank you!!!!!! 
> 
> 
>