|
North American Network Operators Group Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical RE: Zebra Router???
> > Hi All, > > I'm trying to find out what peoples experiences regarding the throughput > > of Zebra on a FreeBSD Box. > > > > My configuration is as follows: > > > > Intel Pentium III 1.40G > > 1 Gig RAM > > 2x <Intel Pro 10/100B/100+ Ethernet> (one internal, one external) on > > board. > > Take a closer look to DEVICE_POLLING kernel option, it can highly > increase fxp network card performance and router's max pps > parameter at all. > > As we tested, typical bottleneck of PC routers is network card irq ratio > that interrupt controller can handle. > > > This box is running as a simple static router, i.e. one subnet on the > > inside, Internet feed on the other side. No BGP, no RIP, no OSPF. Pretty > > simple, eh? > > > > So the goal is to know the bandwidth limitation of this router. > Any ideas? > > I've heard numbers of 35Meg, 40 Meg, etc, however, I have not recieved a > > good reason backing it up. Can anyone offer some input on this? > I would be very surprised if an out of the box FreeBSD router couldn't easily saturate and rate-shape 100Mb/s. Even MBUFS probably wouldn't need to be reconfigured if its just routing. I agree with Dmitry that certain cards are notably more "chatty" with their interrupts than others. It could also be that FreeBSD supports certain cards' extended operation modes better than others. fxp (Intel EtherExpress) and certain other boards are what I consider some of the best supported ones -- Fortunately, they are the most common ones too. If you go higher than 100Mb/s speeds, look for zero-copy boards, especially on the Gigabit side that FreeBSD supports. You have drastically low interrupt overhead and your speeds to move packets around increase. In my experience, its not the CPU that gets bogged down (first) but the interrupt load on a properly configured (software) box. Kevin's 500Mb/s does not suprise me as I have seen those sorts of numbers myself. Now going above 2Gb/s, that's a little trickier. Deepak Jain AiNET
|